Bugfix, deco: fix 2 (small) problems with calculated ceiling This fixes 1 trivial, and 1 not really trivial bug in the calculation of the ceiling. When simulating a bounce dive to 80m, things become clear (tried this on a CCR dive, fixed setpoint 1.2bar, about 15 minutes of bottom time). Closely watch the behavior of the ceiling data. At some point during the ascent, the ceiling begins to decrease in 10cm steps. Then suddenly (while still ascending), the ceiling increases again with 1m, does not change for some time, and then suddenly steps 1.1m less deep. While not very relevant to real deco diving, it is simply wrong. The reason for this is subtle. The algorithm used to find the ceiling is a sort of linear search, stepping down a meter, overshoot the depth, and search back in 10cm steps. It seems some numerical instability. Fixing this, was a bit more computational intensive search by stepping up down in equal steps of 10cm. But, I'm pretty sure that things can be speeded up here, as a ceiling does not change fast, so it should be not that difficult to limit the search space, or use a binary search algorithm instead. The trivial second problem fixed, is that the ceiling ends at the surface and not at 1m depth. This small issue became visible after changing the step down size above. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit