view Small_CPU/Inc/pressure.h @ 642:c737cf5d9067

Do not show focus indicator in case motion detection is suspended: Motion detection will be suspended in case the diver is operating the OSTC using the buttons. In previous versions the focus indicator was shown even the motion detection was not active => may cause confusion. The indicator is now only shown in case the detection is active Added hystresis for switching between sector views: In previous versions small jitter at the angle signal could cause fast switching of the custom view. An offset has now been added to avoid this scenario
author Ideenmodellierer
date Wed, 24 Mar 2021 21:28:41 +0100
parents 4093ac18b25c
children
line wrap: on
line source

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef PRESSURE_H
#define PRESSURE_H

#include <stdint.h>

uint8_t init_pressure(void);
void pressure_set_offset (float pressureOffset, float temperatureOffset);

uint8_t pressure_update(void);
void pressure_update_alternating(void);

uint8_t is_init_pressure_done(void);

HAL_StatusTypeDef  pressure_sensor_get_pressure_raw(void);
HAL_StatusTypeDef  pressure_sensor_get_temperature_raw(void);
void pressure_calculation(void);

float get_temperature(void);
float get_pressure_mbar(void);
float get_surface_mbar(void);

uint8_t is_surface_pressure_stable(void);
float set_last_surface_pressure_stable(void);

void init_surface_ring(uint8_t force);
void update_surface_pressure(uint8_t call_rhythm_seconds);

uint32_t demo_modify_temperature_and_pressure(int32_t divetime_in_seconds, uint8_t subseconds, float ceiling_mbar);

#endif /* PRESSURE_H */