view Small_CPU/Inc/spi.h @ 989:c317130aaafc GasConsumption

OSTC4/5 joined code: In the previous version code differences between OSTC4/5 were identified using the ENABLE_GPIO_V2 compiler switch. In the new version this is done using the display version as indicator which OSTC model is in used. Since this is detected by Firmware the information is forwarded from there to the RTE. This causes a little delay in the GPIO initialization but this applies only to the cold start of the RTE which should not happen very often.
author ideenmodellierer
date Tue, 08 Apr 2025 15:10:14 +0200
parents b3685fbada3b
children
line wrap: on
line source

/**
  ******************************************************************************
  * @file    spi.h
  * @author  heinrichs weikamp gmbh
  * @version V0.0.1
  * @date    16-Sept-2014
  * @brief   Header file for spi control
  ******************************************************************************
  * @attention
  *
  * <h2><center>&copy; COPYRIGHT(c) 2014 heinrichs weikamp</center></h2>
  *
  ******************************************************************************
  */ 

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef SPI_H
#define SPI_H

#ifdef __cplusplus
 extern "C" {
#endif

/* Includes ------------------------------------------------------------------*/
#include "stm32f4xx_hal.h"

extern SPI_HandleTypeDef hspi1;

void MX_SPI1_Init(void);
//void SPI_Start_single_TxRx_with_Master_and_Stop_ChipSelectControl(void);
void SPI_Start_single_TxRx_with_Master(void);
void SPI_synchronize_with_Master(void);
uint8_t SPI_Evaluate_RX_Data(void); /*process the data received during last 100ms cycle */

void MX_SPI_DeInit(void);

	 /* button adjust */
void MX_SPI3_Init(void);
void MX_SPI3_DeInit(void);
uint8_t SPI3_ButtonAdjust(uint8_t *arrayInput, uint8_t *arrayOutput);
void MX_SPI_DeInit(void);


#ifdef __cplusplus
}
#endif
#endif /* SPI_H */

/**
  * @}
  */

/**
  * @}
  */

/************************ (C) COPYRIGHT STMicroelectronics *****END OF FILE****/