Mercurial > public > ostc4

view Documentations/dump-disc.cfg @ 850:bc2fcd002fc4 Evo_2_23

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Check line enable/disable state when a new page is selected: Some lines may change the enable/disable state based on events which are triggered from outside the page scope (for example sensor setup). Updating the line states while another page is active caused problems in the framebuffer handling. To solve this usecase the conditions for the line dis/enabling is checked when a "nextPage" is selected. If condition changed then the page will be refreshed.
author Ideenmodellierer
date Fri, 01 Mar 2024 19:30:29 +0100
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit