view Documentations/dump-disc.cfg @ 538:b1eee27cd02b

BugFix firmware downgrade to version with less settings: If a downgrade to a firmware version using less setting parameter were done then the settings had been reset to the default values. Root cause was that only increased number of settings was accepted by the read function. Because the layout of the setting structure is fixed (only bytes attached, no change in the order of data values) a downgrade just discarding the no longer used settings is possible => Updated read function to handle reduction of setting parameters.
author Ideenmodellierer
date Sat, 10 Oct 2020 13:51:44 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit