Mercurial > public > ostc4
view Documentations/dump-disc.cfg @ 856:af035b883382 Evo_2_23
Do not show SP tab if PSCR mode is active:
In the previous version the setpoint tab was shown even if operation mode PSCR was selected. SPs do not matter for PSCR operation and will not be shown in the new version.
author | Ideenmodellierer |
---|---|
date | Sun, 05 May 2024 17:20:56 +0200 |
parents | 01cc5959f199 |
children |
line wrap: on
line source
#! openocd -f # Define the prob used: source [find interface/stlink-v2.cfg] set WORKAREASIZE 0x8000 transport select hla_swd # Reset options set ENABLE_LOW_POWER 1 set STOP_WATCHDOG 1 reset_config srst_only srst_nogate connect_assert_srst # Seelct the right chip set CHIPNAME stm32f427IIT6 set CONNECT_UNDER_RESET 1 source [find target/stm32f4x.cfg] # Allow to continue execution after a connection: init_reset run puts "Flash banks:" flash banks #puts "Reading FIRMWARE..." # Requires OpenOCD 0.10.0 / released January 2017 ? #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 #puts "Done." exit