cleanup, bugfix: do not mask I2C_SystemStatus with local variable This commit is partly cleanup, and partly possible bugfix. Masking the global I2C_SystemStatus with a local variable is (very) bad practice, but more importantly, dangerous, as other code uses this I2C_SystemStatus to base decisions on. So, this is definitely non-trivial, as it can possibly change the flow of control. This said, its tested and seems to have no negative effects (but also no positive, as I sort of hoped for), so that is why I mark it cleanup as well. Constructs like this shall be heavily documented in the code, when there is a reason to do things like this. Further, remove a 2nd rather useless construct. There is no reason to & 0x03 the output of I2C_SystemStatus. This is the only location in the entire code base where this is done, so, its not only useless but also inconsistent and confusing the true intentions here. Finally, littered to code with todo's that I will take care of in next commits. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit