Bugfix: correct presentation error in tissues custom view The green vertical line in the N2/He bars show the inspired partial pressures of the respective gasses. Obviously, the tissue partial pressure is always lower on an initial descent, than the inspired partial pressure of the respective gas. Further, when for a given depth, the inspired partial pressure is equal to the tissue partial pressure, the tissue gets fully saturated, so the bars stop at the green line. For N2, a simple presentation error was present. As the body is always saturated with about 75% of N2 (according to the Buelmann algorithm), the tissue N2 was shifted left for that amount, but the inspired N2 line was not. So, the N2 green vertical line was too far to the right. Corrected this. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit