Mercurial > public > ostc4

view Documentations/dump-disc.cfg @ 809:9602a7338f28

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
DevBugfix CO2 sensor in streaming mode: In standalone mode (no multiplexer) the CO2 sensor is working in streaming mode => it could happen that the OSTC received data before the scaling factor was requested. As result the CO2 values were calculated with a zero value. This problem has been fixed. In addition some code cleanup has been done. Unifying usage of changeBaudrate function instead of old baud selection based on protocol request of Discovery firmware.
author Ideenmodellierer
date Sun, 27 Aug 2023 20:51:13 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit