Mercurial > public > ostc4

view Documentations/dump-disc.cfg @ 701:8c48553a0176

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Bugfix display of deactivated sensors: In the previous version disabled sensors had been show after startup. Rootcause was that the deactivation state was taken from the divesettings instead of the common setting. After startup divesettings are not initialized and therefore all three sensors were displayed even if one or more were disabled. This has been fixed by using the common settings in case that the OSTC is not in divemode.
author Ideenmodellierer
date Fri, 28 Oct 2022 19:39:20 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit