Bugfix display of disabled screen. It is possible to select a screen as default which is in parallel disabled in the selection view. To avoid this the enable / disable state is not also checked when entering dive mode. The check function was depending on an ACTION. The functionality has been changed to allow the function call without ACTION. Changed setting of compass circle position from constant position to variable This was needed to reuse the same function in several views with different compass position Added new views Navigation and Depth data Both views were basically already available but the idea behind the layout is to combine all information needed for navigation dives (compass + timer) in one view. The classic maxdepth view just showed the maxdepth with a black box on the right side. this box is now used for display of average depth (shown in classic view Stopwatch) Minor changes in compass paint function to improve code readability Use same Y offset for all views While switching across the views some number were shown ~20 pixel higher than others. This was caused by the usage of the line selection which works for some fonts but not for all => set linenumber to 0 for all views

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit