Improvement SPI stability/recoverability The core part of this commit comes from careful code reading. The core is the swap of Scheduler_Request_sync_with_SPI(SPI_SYNC_METHOD_SOFT) and SPI_Start_single_TxRx_with_Master(). This code is sitting in an if-clause that is triggered on SPI comms failure. Instead of blindly trying to communicate again (which will very likely fail again), first try to reset the comms link, and then try to communicate again. That simply makes more sense in this case. This is heavily tested, on 2 simple dives, and 5 very long deco schedules from the simulator (10+ hour deco's), and a lot of small simulated dives (upto 2h runtime). Of all these tests, only one long session failed after 9 out of 11h runtime. Analyzing that one failure, suggests that the RTE is looping in some error handler, which (obviously) results in a SPI comms failure as a result. I consider this not part of this change. Additionally, some more cleanup is done in this code. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

/**
  ******************************************************************************
  * @file    uart.h
  * @author  heinrichs weikamp gmbh
  * @version V0.0.1
  * @date    27-March-2014
  * @brief   button control
  *           
  ******************************************************************************
  * @attention
  *
  * <h2><center>&copy; COPYRIGHT(c) 2015 heinrichs weikamp</center></h2>
  *
  ******************************************************************************
  */ 

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef UART_H
#define UART_H

#ifdef __cplusplus
 extern "C" {
#endif

#include "stm32f4xx_hal.h"

void MX_USART2_UART_Init(void);
void MX_USART2_UART_DeInit(void);
uint8_t UART_ButtonAdjust(uint8_t *array);


#ifdef __cplusplus
}
#endif

#endif /* UART_H */

/************************ (C) COPYRIGHT heinrichs weikamp *****END OF FILE****/