Bugfix T3 skip deactivated views: I previous version the OSTC hangs if only conditional views (like decoplan which is only displayed in case of deco time) are switched. Rootcause was that the select function could never switch to another view because no visible view was available. To avoid this use case a fallback option has been added. In case no other view is available, the current view will be kept. In case no view at all (even no conditional view) is available then a switch to the "None" view will be done independend if it is enabled or not. T3_Profile: Added functionalty to show max depth and divetime of a profile provided by the replay block.

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit