Mercurial > public > ostc4
view Documentations/dump-disc.cfg @ 775:46c6d2380d4e
Add a shortcuts to change the setpoint to the loop to the 'normal' display when diving. It is only shown when diving in CCR mode and on the loop.
Uses the configured setpoint with the highest / lowest switch depth as the high / low setpoints respectively. (mikeller)
author | heinrichsweikamp |
---|---|
date | Thu, 11 May 2023 12:13:03 +0200 |
parents | 01cc5959f199 |
children |
line wrap: on
line source
#! openocd -f # Define the prob used: source [find interface/stlink-v2.cfg] set WORKAREASIZE 0x8000 transport select hla_swd # Reset options set ENABLE_LOW_POWER 1 set STOP_WATCHDOG 1 reset_config srst_only srst_nogate connect_assert_srst # Seelct the right chip set CHIPNAME stm32f427IIT6 set CONNECT_UNDER_RESET 1 source [find target/stm32f4x.cfg] # Allow to continue execution after a connection: init_reset run puts "Flash banks:" flash banks #puts "Reading FIRMWARE..." # Requires OpenOCD 0.10.0 / released January 2017 ? #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 #puts "Done." exit