Mercurial > public > ostc4
view Small_CPU/Inc/batteryCharger.h @ 757:39ff186b6f98
Dev Bugfix: ignore analog out of bounds limits for DiveO2 sensor:
The DiveO2 sensor provides a status information which may be used to identify if the value is valid or not. The sensor does not provide a voltage => to have a value for the voltage the value of the ppo2 is taken (equals calibration coeff of 1). For the analog out of bounds detection this value is too high and the DiveO2 is marked as out of bounds. To avoid this problem DiveO2 sensors are now excluded from the analog out of bounds detection.
author | Ideenmodellierer |
---|---|
date | Tue, 07 Mar 2023 22:14:20 +0100 |
parents | 1b995079c045 |
children | d32901746950 |
line wrap: on
line source
/** ****************************************************************************** * @file batteryCharger.h * @author heinrichs weikamp gmbh * @date 09-Dec-2014 * @version V0.0.1 * @since 09-Dec-2014 * @brief LTC4054 Standalone Linear Li-Ion Battery Charger * @verbatim ============================================================================== ##### How to use ##### ============================================================================== @endverbatim ****************************************************************************** * @attention * * <h2><center>© COPYRIGHT(c) 2015 heinrichs weikamp</center></h2> * ****************************************************************************** */ /* Define to prevent recursive inclusion -------------------------------------*/ #ifndef BATTERY_CHARGER_H #define BATTERY_CHARGER_H #ifdef __cplusplus extern "C" { #endif /* Includes ------------------------------------------------------------------*/ #include <stdint.h> #define CHARGE_IN_PIN GPIO_PIN_2 #define CHARGE_IN_GPIO_PORT GPIOC #define CHARGE_IN_GPIO_ENABLE() __GPIOC_CLK_ENABLE() #define CHARGE_OUT_PIN GPIO_PIN_1 #define CHARGE_OUT_GPIO_PORT GPIOC #define CHARGE_OUT_GPIO_ENABLE() __GPIOC_CLK_ENABLE() typedef enum { Charger_NotConnected = 0, /* This is identified reading CHARGE_IN_PIN == HIGH */ Charger_WarmUp, /* Charging started but counter did not yet reach a certain limit (used to debounce connect / disconnect events to avoid multiple increases of statistic charging cycle counter) */ Charger_Active, /* Charging identified by CHARGE_IN_PIN == LOW for a certain time */ Charger_Finished, Charger_LostConnection, /* Intermediate state to debounce disconnecting events (including charging error state like over temperature) */ Charger_ColdStart, /* Cold start condition => check if an loaded battery has been inserted */ Charger_END } chargerState_t; uint8_t get_charge_status(void); void init_battery_charger_status(void); void set_charge_state(chargerState_t newState); uint8_t get_charge_state(void); void ReInit_battery_charger_status_pins(void); void DeInit_battery_charger_status_pins(void); void battery_charger_get_status_and_contral_battery_gas_gauge(uint8_t cycleTimeBase); #ifdef __cplusplus } #endif #endif /* BATTERY_CHARGER_H */ /************************ (C) COPYRIGHT heinrichs weikamp *****END OF FILE****/