view Documentations/dump-disc.cfg @ 804:391b3d420a39

Cleanup initialisation code: Some variables were not initialised during awake transition and the mapping of to the legacy adc slots were done at several location. This has been cleaned up not. Do not run UART during ADC sensor detection: A operation UART sensor caused the false detection of a not connected ADC sensor. To avoid this the UART is now deactivated during ADC detection phase.
author Ideenmodellierer
date Thu, 10 Aug 2023 21:35:34 +0200 (16 months ago)
parents 01cc5959f199
children
line wrap: on
line source
#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit