Mercurial > public > ostc4

view Documentations/dump-rte.cfg @ 792:25103f5c7e29

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Avoid a configuration warning after the firmware upgrade by disabling automatic setpoint switching. This makes sure the user's automatic setpoint configuration is not overwritten by the validity checks if the settings are not in the correct spots for the new configuration. Users will have to manually re-create the automatic setpoint switching configuration in the new format; Add a checkbox to 'SPdeco' in the menu - this will make it obvious to users that this setpoint can be disabled. (mikeller)
author heinrichsweikamp
date Sat, 05 Aug 2023 11:52:08 +0200
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit