Mercurial > public > ostc4

view Documentations/dump-disc.cfg @ 1046:1d7c7a36df15 GasConsumption

Find changesets by keywords (author, files, the commit message), revision number or hash, or revset expression.
Bugfix OSTC5 BT and enabling fast mode: The OSTC5 BT was operating at default speed of 115200. To enable the faster communication some init steps have been added to set speed to 460800. Having the UART enabled while the module was shut down caused problems during initialisation. To avoid these the BT UART is now initialized after the the module is powered on and deinitialized while the module is switched off.
author Ideenmodellierer
date Fri, 14 Nov 2025 18:54:20 +0100
parents 01cc5959f199
children
line wrap: on
line source

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit