Bugfixes and code cleanup for BF views: BF views gauge and apnoe were using "dive computer" T3 view functions which caused some problem because these legacy views were not intended to work with customer view selection. A switch condition has been added to skip these kind of functions in case a design other T3 is in use. Another potential problem was that there were two definitions for T3 and T7 views which were basically the same. If they wold not be the same the switching functionality wold not work properly. To avoid this problem in futur the arrays have been merged => the view are handled sing the (newer) cv_view arrays instead of the standard_views which were in used before the user could the views which should be shown.

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f411RETx
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

#puts "Flash banks:"
#flash banks

#puts "Reading..."
#flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000

#puts "Done."
#exit