Mercurial > public > ostc4
view Small_CPU/Src/uart.c @ 580:08af5d707c5a
Bugfix bad resolution of compass LSM303AGR:
The values of the variant LSM303AGR were more instabled compared to other variants. Root cause was that low power and high resolution are set in different registers and both options were enabled what is an invalid configuration => most likely the request for high resolution was ignored. To fix this the low power mode is only set in sleep and the high resolution is used in normal operation => compass performance same as in other variants.
author | Ideenmodellierer |
---|---|
date | Sat, 12 Dec 2020 19:16:37 +0100 |
parents | 5f11787b4f42 |
children | 1b995079c045 |
line wrap: on
line source
/** ****************************************************************************** * @file uart.c * @author heinrichs weikamp gmbh * @version V0.0.1 * @date 27-March-2014 * @brief button control * @verbatim ============================================================================== ##### How to use ##### ============================================================================== @endverbatim ****************************************************************************** * @attention * * <h2><center>© COPYRIGHT(c) 2015 heinrichs weikamp</center></h2> * ****************************************************************************** */ /* Includes ------------------------------------------------------------------*/ #include "uart.h" /* Private variables ---------------------------------------------------------*/ UART_HandleTypeDef huart2; /* Exported functions --------------------------------------------------------*/ void MX_USART2_UART_Init(void) { /* pullup special */ GPIO_InitTypeDef GPIO_InitStructure; __GPIOA_CLK_ENABLE(); GPIO_InitStructure.Pin = GPIO_PIN_2; GPIO_InitStructure.Mode = GPIO_MODE_OUTPUT_PP; GPIO_InitStructure.Pull = GPIO_PULLUP; GPIO_InitStructure.Speed = GPIO_SPEED_FAST; HAL_GPIO_Init(GPIOA, &GPIO_InitStructure); /* regular init */ huart2.Instance = USART2; huart2.Init.BaudRate = 1200; huart2.Init.WordLength = UART_WORDLENGTH_8B; huart2.Init.StopBits = UART_STOPBITS_1; huart2.Init.Parity = UART_PARITY_NONE; huart2.Init.Mode = UART_MODE_TX_RX; huart2.Init.HwFlowCtl = UART_HWCONTROL_NONE; huart2.Init.OverSampling = UART_OVERSAMPLING_16; HAL_UART_Init(&huart2); } uint8_t UART_ButtonAdjust(uint8_t *array) { uint8_t answer[4]; HAL_UART_Transmit(&huart2,array,4,1000); HAL_UART_Receive(&huart2,answer,4,2000); if( (answer[0] == array[0]) &&(answer[1] == array[1]) &&(answer[2] == array[2]) &&(answer[3] == array[3])) return 1; else return 0; } void MX_USART2_UART_DeInit(void) { HAL_UART_DeInit(&huart2); } /************************ (C) COPYRIGHT heinrichs weikamp *****END OF FILE****/