Bugfix: make max depth move with current depth (part 1) The display in dive mode of the max depth was updated before the actual depth, which looks very strange. The reason for this was conceptually simple. The depth value was averaged over a set of depth samples, but the current depth was only taken from the current sample. So, per definition, on an initial descend, the current depth is always bigger (deeper) than any average from previous shallower samples. This part 1 commit introduces a new function that is used immediate after reception of the new sample from the RTE. This function does the trivial average of a set of samples. Notice that also the surface and ambient mbar pressures are taken into account (which are used heavily over the entire code). This is a consistency thing. We should base any further calculation from the data presented in the UI, instead of presenting A, and use A' for further calculations. Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>

/**
  ******************************************************************************
  * @file    uart.h
  * @author  heinrichs weikamp gmbh
  * @version V0.0.1
  * @date    27-March-2014
  * @brief   button control
  *           
  ******************************************************************************
  * @attention
  *
  * <h2><center>&copy; COPYRIGHT(c) 2015 heinrichs weikamp</center></h2>
  *
  ******************************************************************************
  */ 

/* Define to prevent recursive inclusion -------------------------------------*/
#ifndef UART_H
#define UART_H

#ifdef __cplusplus
 extern "C" {
#endif

#include "stm32f4xx_hal.h"

void MX_USART2_UART_Init(void);
void MX_USART2_UART_DeInit(void);
uint8_t UART_ButtonAdjust(uint8_t *array);


#ifdef __cplusplus
}
#endif

#endif /* UART_H */

/************************ (C) COPYRIGHT heinrichs weikamp *****END OF FILE****/