Redefine Deco gas creation function: The old function needed a lot of iteration to get through all gases. With the change to define the first gas in PSCR mode as deco gas for calculation (because the actual gas could be not breathable close to surface => deco planing would be based on > 80% nitrogen increasing the deco prediction higher than necessary) the need showed up to somehow define the first gas as deco gas. Instead of manipulating the gas attribute the deco list creation function was changed to create the list based on gas line pointer information instead of index lists. The new function needs less iterations for sorting and is more flexible regarding gas handling.

#! openocd -f
# Define the prob used:
source [find interface/stlink-v2.cfg]
set WORKAREASIZE 0x8000
transport select hla_swd

# Reset options
set ENABLE_LOW_POWER 1
set STOP_WATCHDOG 1
reset_config srst_only srst_nogate connect_assert_srst

# Seelct the right chip
set CHIPNAME stm32f427IIT6
set CONNECT_UNDER_RESET 1
source [find target/stm32f4x.cfg]

# Allow to continue execution after a connection:
init_reset run

puts "Flash banks:"
flash banks

#puts "Reading FIRMWARE..."
# Requires OpenOCD 0.10.0 / released January 2017 ?
#flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000

#puts "Done."
exit