Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 926:875933272056 Evo_2_23 tip
Bugfix sensor de-/activation handling:
In the previous version a CO2 sensor could cause a not used analog channel to be displayed. Rootcause was that all sensor type, not only o2 sensors, were used for o2 sensor deactivation evaluation. The deactivation state is the criteria if a value is displayed or not.
In the new version only o2 sensor type are used for handling of sensor de-/activation state.
In addition the cursor will now be set to the first valid sensor entry in case sensor slot 0 is empty.
| author | Ideenmodellierer |
|---|---|
| date | Thu, 14 Nov 2024 20:13:18 +0100 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f427IIT6 | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 puts "Flash banks:" | |
| 21 flash banks | |
| 22 | |
| 23 #puts "Reading FIRMWARE..." | |
| 24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
| 25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
| 26 | |
| 27 #puts "Done." | |
| 28 exit |