Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 864:fa431d42b5fb
Fix incorrect logging of bailout to Open Circuit when using the best gas.
This happened because the starting gas used for 'best gas' calculation
was a diluent - in most cases not a problem as the same gas is also
used as a bailout gas. Now use the 'first' open circuit gas configured as the
starting point.
Also fixes the problem of a custom bailout gas not being logged as such,
and consequently not being shown as bailout in the on-device log.
| author | heinrichsweikamp |
|---|---|
| date | Mon, 22 Jul 2024 16:38:36 +0200 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f411RETx | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 #puts "Flash banks:" | |
| 21 #flash banks | |
| 22 | |
| 23 #puts "Reading..." | |
| 24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
| 25 | |
| 26 #puts "Done." | |
| 27 #exit |