Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 729:d646a0f724a7
Added auto detection functionality for sensors connected to the external interface:
O2 sensors may be connected to the analog input as well as to the UART. The GUI visualization provides three slots for ppo2 display. Beside detection of sensor kind the task of the function is to place the available sensor in this three slots. CO2 has its own communication slot outside the ppo2 channel.
The result of the automatic detection is communicated via the sensor map.
author | Ideenmodellierer |
---|---|
date | Sat, 14 Jan 2023 20:46:17 +0100 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f427IIT6 | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 puts "Flash banks:" | |
21 flash banks | |
22 | |
23 #puts "Reading FIRMWARE..." | |
24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
26 | |
27 #puts "Done." | |
28 exit |