Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 859:d32901746950 Evo_2_23
Improvment battery charger visualization:
In the previous version the green flash (charge complete) was shown even battery had not reached 100% charge. Root cause was that the pin signaling the end of charge could be raised for other reasons then a full battery. The new version will show the green flash only in case the battery is rated as full.
In addition the graph visualization has been updated to continously progress. In the previous version it only progressed in case the charge value changed. Especially at charging start the charger is doing some battery evaluation which does not increase the charge state. In such a case the graph seemed to be frozen.
| author | Ideenmodellierer |
|---|---|
| date | Tue, 07 May 2024 21:20:33 +0200 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f427IIT6 | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 puts "Flash banks:" | |
| 21 flash banks | |
| 22 | |
| 23 #puts "Reading FIRMWARE..." | |
| 24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
| 25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
| 26 | |
| 27 #puts "Done." | |
| 28 exit |