Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 636:c47766ec3f96
Debounce fallback warning:
In previous versions the fallback option (automatical setting of a fixed setpoint) was only done for communication timeout scenario in combination with a HUD. It is now also applied in case all sensors are rated as out of bounds. The signaling of the fallback warning (including optional automatic setpoint change) is now done taking a 5 seconds debounds time into account.
In case a fallback warning is active, then the only way to reset it is by selecting a new setpoint or by changing the sensor configuration (no change compared to previous implementation
| author | Ideenmodellierer |
|---|---|
| date | Wed, 24 Feb 2021 21:03:54 +0100 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f427IIT6 | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 puts "Flash banks:" | |
| 21 flash banks | |
| 22 | |
| 23 #puts "Reading FIRMWARE..." | |
| 24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
| 25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
| 26 | |
| 27 #puts "Done." | |
| 28 exit |