Mercurial > public > ostc4
annotate Documentations/dump-rte.cfg @ 850:bc2fcd002fc4 Evo_2_23
Check line enable/disable state when a new page is selected:
Some lines may change the enable/disable state based on events which are triggered from outside the page scope (for example sensor setup). Updating the line states while another page is active caused problems in the framebuffer handling. To solve this usecase the conditions for the line dis/enabling is checked when a "nextPage" is selected. If condition changed then the page will be refreshed.
author | Ideenmodellierer |
---|---|
date | Fri, 01 Mar 2024 19:30:29 +0100 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f411RETx | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 #puts "Flash banks:" | |
21 #flash banks | |
22 | |
23 #puts "Reading..." | |
24 #flash dump_image CPU2-RTE-dump.hex 0x00000000 0x8000 | |
25 | |
26 #puts "Done." | |
27 #exit |