Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 857:ba1aebc6d5af Evo_2_23
Developer feature debug warning:
The debug warnings are only available to developers who activate the feature via compile switch. After that it is possible to define a condition and a content of a warning which will be shown if a special situation occure (visualized in the main view as already done for other warnings like ppo2). In the first implementation details regarding the error state of the DiveO2 will be shown in case the sensor reports a problem. Feel free to change the implementation in case you want to observe another behavior.
author | Ideenmodellierer |
---|---|
date | Sun, 05 May 2024 17:27:28 +0200 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f427IIT6 | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 puts "Flash banks:" | |
21 flash banks | |
22 | |
23 #puts "Reading FIRMWARE..." | |
24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
26 | |
27 #puts "Done." | |
28 exit |