Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 307:b6436edfb2c0 cleanup-4
cleanup: factor out unused stopwatch code
Visually, this looks a bit of a dangerous cleanup, but its not :-)
To explain this cleanup: stopwatch_seconds is never used, so assign
to it is useless, and the variable can be removed. Now,
stopwatch_start_at_this_dive_time_seconds is not used any more, so
remove it as well. Now, look at the boolResetStopwatch code. It
is used but only to reset itself. This makes the whole stopwatch
block in data_exchange_main.c a useless thing. All the other
cleanup is trivial.
Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>
| author | Jan Mulder <jlmulder@xs4all.nl> |
|---|---|
| date | Wed, 22 May 2019 22:22:15 +0200 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f427IIT6 | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 puts "Flash banks:" | |
| 21 flash banks | |
| 22 | |
| 23 #puts "Reading FIRMWARE..." | |
| 24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
| 25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
| 26 | |
| 27 #puts "Done." | |
| 28 exit |