Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 339:37f45300bc2e PressureMeasure_Improvment
Apply averaging to pressure measurement: In pre versions calculated pressure value jittered +/-10hPa. Since we measure the pressure several time a second but only use one value a second, calc average including not used values
Activated pressure / temperature offsets: The functionality to store offsets was already present in the firmware but values have not been apllied in the RTE => added functionality to include offsets in calculation
Set Max possible surface pressure to 1070hPa (Black sea level)
author | ideenmodellierer |
---|---|
date | Sat, 17 Aug 2019 19:03:47 +0200 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f427IIT6 | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 puts "Flash banks:" | |
21 flash banks | |
22 | |
23 #puts "Reading FIRMWARE..." | |
24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
26 | |
27 #puts "Done." | |
28 exit |