Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 169:842f57bbaaad cleanup-1
Bugfix: highlight the menu underline correctly on selected state
This fixes an optical bug. In dive and simulation mode, the
underline in the top menu was not highlighted correctly for the
DECO ans SYS submenu's. The check when to highlight simply was not
correct. And, yes, this part of the code is rather obfuscated, and
deserves some attention later on.
Reported-by: Matthias Heinrichs <matthias.heinrichs@heinrichsweikamp.com>
Signed-off-by: Jan Mulder <jlmulder@xs4all.nl>
author | Jan Mulder <jlmulder@xs4all.nl> |
---|---|
date | Sun, 10 Mar 2019 10:09:58 +0100 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f427IIT6 | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 puts "Flash banks:" | |
21 flash banks | |
22 | |
23 #puts "Reading FIRMWARE..." | |
24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
26 | |
27 #puts "Done." | |
28 exit |