Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 983:7891160acde3 GasConsumption
Bugfix calculation of needed gas:
Sometimes a gas was not calculated because of it's change depth calculation. Rootcause was a problem in the setup of the gas change list. The old function collecting milestones like time to first stop etc. has been removed because after the deco compression the complete profile is available. Instead of doing another way of profile calculation the existing profil is now evaluated and the time stamps / gas consumption derived from there.
| author | Ideenmodellierer |
|---|---|
| date | Sun, 02 Mar 2025 21:43:08 +0100 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f427IIT6 | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 puts "Flash banks:" | |
| 21 flash banks | |
| 22 | |
| 23 #puts "Reading FIRMWARE..." | |
| 24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
| 25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
| 26 | |
| 27 #puts "Done." | |
| 28 exit |
