Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 406:439874690f85 Improment_NVM
Bugfix Min max values for device data checks:
Devicedata was set to it lower limit in case of a lower invalid value and upper limit in case a bigger value was detected. This could cause the history memory to be set to a min / max limit and never beeing updated again => Implemented a selection to specify which limit shall be used as default.
Minor change: "header" was used as global as well as as local variable => changed name for global variant to gheader.
Operation hours were not updated =>adde check for opeartion hours
author | ideenmodellierer |
---|---|
date | Sun, 12 Jan 2020 17:57:11 +0100 |
parents | 01cc5959f199 |
children |
rev | line source |
---|---|
34 | 1 #! openocd -f |
2 # Define the prob used: | |
3 source [find interface/stlink-v2.cfg] | |
4 set WORKAREASIZE 0x8000 | |
5 transport select hla_swd | |
6 | |
7 # Reset options | |
8 set ENABLE_LOW_POWER 1 | |
9 set STOP_WATCHDOG 1 | |
10 reset_config srst_only srst_nogate connect_assert_srst | |
11 | |
12 # Seelct the right chip | |
13 set CHIPNAME stm32f427IIT6 | |
14 set CONNECT_UNDER_RESET 1 | |
15 source [find target/stm32f4x.cfg] | |
16 | |
17 # Allow to continue execution after a connection: | |
18 init_reset run | |
19 | |
20 puts "Flash banks:" | |
21 flash banks | |
22 | |
23 #puts "Reading FIRMWARE..." | |
24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
26 | |
27 #puts "Done." | |
28 exit |