Mercurial > public > ostc4
annotate Documentations/dump-disc.cfg @ 792:25103f5c7e29
Avoid a configuration warning after the firmware upgrade by disabling automatic setpoint switching. This makes sure the user's automatic setpoint configuration is not overwritten by the validity checks if the settings are not in the correct spots for the new configuration. Users will have to manually re-create the automatic setpoint switching configuration in the new format;
Add a checkbox to 'SPdeco' in the menu - this will make it obvious to users that this setpoint can be disabled. (mikeller)
| author | heinrichsweikamp |
|---|---|
| date | Sat, 05 Aug 2023 11:52:08 +0200 |
| parents | 01cc5959f199 |
| children |
| rev | line source |
|---|---|
| 34 | 1 #! openocd -f |
| 2 # Define the prob used: | |
| 3 source [find interface/stlink-v2.cfg] | |
| 4 set WORKAREASIZE 0x8000 | |
| 5 transport select hla_swd | |
| 6 | |
| 7 # Reset options | |
| 8 set ENABLE_LOW_POWER 1 | |
| 9 set STOP_WATCHDOG 1 | |
| 10 reset_config srst_only srst_nogate connect_assert_srst | |
| 11 | |
| 12 # Seelct the right chip | |
| 13 set CHIPNAME stm32f427IIT6 | |
| 14 set CONNECT_UNDER_RESET 1 | |
| 15 source [find target/stm32f4x.cfg] | |
| 16 | |
| 17 # Allow to continue execution after a connection: | |
| 18 init_reset run | |
| 19 | |
| 20 puts "Flash banks:" | |
| 21 flash banks | |
| 22 | |
| 23 #puts "Reading FIRMWARE..." | |
| 24 # Requires OpenOCD 0.10.0 / released January 2017 ? | |
| 25 #flash dump_image CPU1-DISC-dump.hex 0x00000000 0x8000 | |
| 26 | |
| 27 #puts "Done." | |
| 28 exit |